Home | Available Used Machinery | New Machinery | Your Surplus Machinery | Your Machinery Needs | Appraisal | Email Us to Request a Quote.

Okuma ES-L6 CNC Combination Lathe, New 2005.

Specifications: 

No. of controlled axes…………………………………………. 2

Swing over bed…………………………………………... 17.72"

Swing over carriage……………………………………… 13.78"

Swing over cross slide…………………………………… 11.81"

Max. turning diameter x length………………….. 8.27" x 11.02"

Spindle diameter…………………………………………... 3.15"

Spindle nose type…………………………………… 140mm flat

Through spindle hole……………………………………… 2.09"

Bar capacity……………………………………………….. 1.75"

No. of spindle speed ranges……………………………. Stepless

Spindle speed………………………………….. 133 to 6000 rpm

X-axis travel………………………………………………. 6.10"

Z-axis travel……………………………………………….. 12.6"

Rapid feedrate X/Z………………………………… 590/787 ipm

Turret type………………………………………………….. V12

Tool size od…………………………………………………… 1"

Tool size id………………………………………………… 1.25"

Tailstock spindle diameter………………………………… 2.17"

Tailstock spindle taper hole……………………………… #4 MT

Tailstock spindle travel…………………………………..... 3.94"

Spindle drive motor…………………………………... 10/7.5 Hp

Dimensions (approx.)……………….. 75.2"L x 67.6"D x 67.3"H

Weight (approx.)……………………………………….. 6,179 lb.

Equipped with:

OSP U100L CNC control with MacMan

ATS 5C Hyd. Collet chuck

12 Station turret

Tailstock

Chip conveyor

All available tool holders

All available manuals

DESCRIPTIONS ARE CORRECT TO THE BEST KNOWLEDGE OF THE SELLER BUT ARE NOT GUARANTEED.
BUYERS ARE ENCOURAGED TO CHECK IMPORTANT CHARACTERISTICS.

Email Us to Request a Quote.

Home | Available Used Machinery | New Machinery | Your Surplus Machinery | Your Machinery Needs | Appraisal

- FINANCING BY DIRECT CAPITAL -.